Asphalt Academy WebinarsISSA Logo

Mix Design Methods for Slurry Seal/ Microsurfacing and Chip Seals Webinar Recording
(1.5 hrs., 1.5 PDHs)

To register & view any or all of these recordings see below
$50 per session


Description
Description:  Mix designs are an integral part of the overall performance of Slurry Seal, Microsurfacing and Chip Seals. For mix design of Slurry Seals and Micros, there are several recommended sources including ASTM D3910, ISSA A-105 & ISSA A-143 and MS-19 Basic Asphalt Emulsion Manual. In the lab, blending of the materials that are to be used in the field is done in varying proportions to select the proper formulation. Lab tests are conducted to ensure a slurry mixture that performs well during placement and under traffic. For Chip Seals, there are procedures for determining the proper quantity of asphalt binder and cover aggregate. Material properties of the stone and asphalt are first obtained, and then calculations and lab testing performed to determine the required quantities. Adjustments must be made to account for traffic volume, absorption of the binder into the existing pavement and cover aggregate, characteristics of the cover aggregate, etc.

This webinar will illustrate the mix design process first for Slurry Seal/ Microsurfacing, and then move into the same for Chip Seals. Discussion for each treatment will include component material analysis, proportion optimization, performance testing, final formulation adjustments and recommendations.

•  Slurry Seal/ Microsurfacing mix design requirements and standard methods.
•  Chip Seal mix design requirements and standard methods
•  Highlight each performance test and its purpose
•  Discuss the importance of specified tolerances
•  Emphasize importance of proportioning according to the job mix formula in the lab and later in the field
•  Illustrate that failure to adhere to the mix design proportions will lends itself to performance issues


Instructor
Debbie Deep – MeadWestvaco Corp (Slurry Seal & Microsurfacing)
Larry Tomkins – Ergon Asphalt & Emulsions, Inc (Chip Seals)

Instructions for viewing a recorded webinar (PDF 706 kb)

(A PDH Certificate is available upon request after you view the recording by sending an email to ai_webinars@asphaltinstitute.org with the name of the session and full name you used to register)

Fees & Registration
The registration fee is $50.

Register online to view the webinar recording.

NOTE: Registration is per individual. Only the registered person will receive emails about the webinar and will be recognized for a PDH certificate.
See below for group registration.

Group Registrations and Discounts
Group Registration and discounts are available upon request.

  • We encourage and support group registrations for AI’s live and recorded events
  • A webinar “group” is more than 1 individual sharing a single computer (with or without a projector) to view a webinar at the same time at a single location.
  • Each group must have a designated Group Coordinator who will serve as the point of contact for all communications such as the access code and instructions
  • The Group Coordinator will be charged the full undiscounted registration cost of $50 for each session registered for. All additional attendees will be charged a discounted fee of $30 per person for each session registered for.
  • Group registrations can be requested by clicking this link: Group Registration and PDH Certificate Policy and completing the form ; or contacting Charlena Gray via phone or email at 859-288-4961 or cgray@asphaltinstitute.org
  • Each registered group participant will receive a PDH also if requested.

 

For more information contact
webmaster@asphaltinstitute.org